8
INSTRUCTION MANUAL · WILFA PERFORMANCE
EN
BEFORE USE
ELECTRICAL CONNECTION
Check that the voltage where you shall use the unit is the same as that specied
on the unit. Details can be found on the label on the unit’s base plate.
WHEN USING THE UNIT FOR THE FIRST TIME
Please run 1.25L fresh water through the unit without using a coffee lter or
coffee prior to using the unit for the rst time.
OPERATION
• Place the Wilfa Performance on a at surface. Plug the power cord into the
socket.
• Turn the on/off power switch on. Start button will blink twice and one beep
will be heard.
• Fill the water tank with fresh water to the desired amount. Place a lter paper
(1x4) in the lter holder. Place the recommended amount of coffee into the
lter.
• We recommend that you use lter ground coffee, 60 g per litre of water.
Experiment with the coffee quantities for the rst few brewing’s to nd the
amount which you think is optimal.
• We also recommend that you use a Wilfa scale for best results.
• Attach the lter holder to the bracket. Set the ow control in relation to your
desired brew preference.
• We recommend the following ratios of water and coffee (please note that
different grinds and coffee types will inuence these ratios somewhat):
1,25 l - 75 g
1 l - 60 g
0,75 l - 45 g
0,50 l - 30 g
• Press the start button to start the brewing process. Wilfa Performance has
Wilfa’s unique pump system which transports water through the system at an
optimal temperature from the rst to the last drop.
• When the brewing process is complete, the unit will switch over to the keep
warm state. The start button will remain lit up. After 40 minutes the coffee
maker will automatically be switched off. If you want to switch off the coffee
maker before 40 minutes (with light in start button) just press the start button
once and the coffee maker will be switched off.
To Next Page
Loading...
Need help?
General
