10
INSTRUCTION MANUAL · WILFA PERFORMANCE
EN
TROUBLESHOOTING
Problem Possible reasons Solutions
Coffee maker does
not start
Power cord is not
plugged in.
Power switch is not “on”
No water in the water
tank
Pump is dry
Plug into power socket
Turn on power switch (see No.1
in the description)
Fill the water tank
Run the unit with it’s water tank
filled to maximum capacity
(1.25L)
Coffee maker
stops
Limescale in the product Descale the coffee maker
The coffee is not
hot enough
The glass jug is very
cold
Preheat the jug with hot water
Filter holder
overflowing
Drip-stop is locked
Coffee ground clogging
the flow-control valve at
the bottom of the filter
holder.
Coffee too finely ground
Open the drip-stop
Set the flow control to 1,25
and rinse the filter holder by
running water through it.
Use filter coffee
• Never wash other parts of the device in the dishwasher. Never use strong
detergents, scouring powders, steel wool or other release agents on any part
of the coffee maker.
DESCALING
• Use a commercially available descaling detergent.
• Descaling should be done, as needed. In areas with hard water, descaling
must be done regularly.
To Next Page
Loading...
Need help?
General
