Need help?Do you have a question about the Willhi WH7016C and is the answer not in the manual?
General| Temperature Measurement Error | ±0.5 °C |
|---|---|
| Sensor Type | Thermistor |
| Power Supply | AC 220V |
| Display | LED |
| Data Storage | Non-volatile Memory |
| Enclosure Rating | IP20 |
| Type | Digital Temperature Controller |
| Sensor Model | NTC |
| Contact Current | 10A |
| Control Output | Relay Output |
| Control Type | On/Off |
| Differential | 0.1°C to 10°C adjustable |
Specifies the dimensions required for mounting the thermostat.
Illustrates how to connect the load, power, and sensor.
Details the operational parameters like measurement range, accuracy, and voltage.
Explains the operation of the RST and SET buttons for control.
Describes the meaning of the WORK and SET LED lights on the display.
Details the logic and examples for cooling and heating functionalities.
Procedure to set the thermostat for cooling (C) or heating (H) mode.
Defines the temperature interval for switching the output on/off.
Guide to setting the hysteresis value for temperature control.
Function to correct temperature readings for accuracy.
Prevents rapid cycling, especially for compressor-based cooling.
Sets the range for acceptable control temperature points.
Lists and explains the codes for various settings like HC, D, LS, HS, CA, PT.
Provides guidance on common issues like sensor disconnection or out-of-range temperatures.
Highlights important safety and operational warnings for proper use.
To Next Page
