Some Points to Remember
• Learn to recognize the odor of LP Gas.
Your local LP Gas Dealer can give you a "Scratch and Sniff" pamphlet. Use
it to find out what the propane odor smells like. If you suspect that your LP Gas has a weak or abnormal odor, call your
LP Gas Dealer.
•
If you are not qualified, do not light pilot lights, perform service, or make adjustments to furnaces on the LP Gas
system. If you are qualified, consc
iously think about the odor of LP Gas prior to and while lighting pilot lights or
performing service or making adjustments.
• Sometimes a basement or a closed-up house has a musty smell that can cover up the LP Gas odor. Do not try to light pilot
lights, perform service or make adjustments in an area where the conditions are such that you may not detect the odor if
there has been a leak of LP Gas.
• Odor fade, due to oxidation by rust or absorption on walls of new cylinders and tanks, is possible. Therefo
should be particularly alert and careful when new tanks or cylinders are placed in service. Odor fade can occur in new
tanks or reinstalled old tanks if they are filled and allowed to set too long before refilling. Cylinders and tanks whic
been out of service for a time may develop internal rust which will cause odor fade. If such conditions are suspected to
exist, a periodic sniff test of the gas is advisable.
If you have any question about the gas odor, call your LP Gas dealer.
A periodic sniff test of the LP Gas is a good safety measure under any condition.
• If, at any time, you do not smell the LP-Gas odorant, and you should, assume you have a leak. Then take the same
immediate action recommended above for the occasion when you do smell the odorized LP Gas.
• If you experience a complete "gas out" (the container is under no vapor pressure), turn the tank valve off immediately.
If the container valve is left on, the container may draw in some air through openings such as pilot light orifices.
If this occurs, some new internal rusting could occur. If the valve is left open, then treat the container as a new tank.
Always be sure your container is under vapor pressure by turning it off at the container before it goes completely empty
or
having it refilled before it is completely empty.
Technical Data
OUTPUT HEATING CAPACITY
MANIFOLD PRESSURE
MAX
NATURAL
GAS
kBTU/hr 23,817 in
W.C.
3.2
INPUT RATING (High Input)
kW 8.5
LP
mbar 26.5
kBTU/hr 29,000 in
W.C.
10.6
MINIMUM INPUT RATING
(Low Input)
kW 5.89
MIN
NATURAL
GAS
mbar 4.6
kBTU/hr 20,100 in
W.C.
1.8
THERMAL EFFICENCY % 82
LP
mbar 16.2
LENGTH
mm 1006 in
W.C.
6.5
in 39-5/8”
GAS RATE
MAX
NATURAL
GAS
m
3
/h .9
HEIGHT
mm 715
ft
/h 30.1
in 28-1/8”
LP
m
3
/h .3
DEPTH
mm 208 ft
3
/h 11.6
in 8-1/4”
MIN
NATURAL
GAS
m
/h .6
WEIGHT
kg 42 ft
3
/h 21.3
lbs. 93
LP
m
/h .2
GAS CONNECTION NPT
½” FEMALE
ft
/h 8.7
WALL HOLE DIAMETER
mm 50
MINIMUM INLET
PRESSURE
NATURAL
GAS
mbar 17.4
in 2” in
W.C.
7.0
AIR INLET DIAMETER
mm 49
LP
mbar 27.4
in 1-7/8” in
W.C.
11.0
EXHAUST PIPE DIAMETER
mm 35
AIR FLOW
m³/h 450
in 1-3/8” cfm 265
MAX WALL THICKNESS
mm 500
MINIMUM AIR FLOW
m³/h 330
in 19-5/8” cfm 194
MIN WALL THICKNESS
mm 150
in 5-7/8”
To Next Page
Loading...
