23
Willow Go
™
Breast Pump | Instructions for Use
Sanitization - Before First Use and As Needed
•
Pump: Wipe with 70-90% ethyl or isopropyl alcohol
•
Washable Parts
- Clean rst
- Boil in water for 5 minutes, remove with clean tongs
- Allow to air dry on clean surface (e.g., clean paper
towel or clean drying rack)
Cleaning - Before First Use and After Each Use
•
Disassemble parts
•
Rine milk-contacting parts immediately in warm water
•
Soak with agitation for 5 minutes in hot, soapy water. Use mild
dishwashing soap.
•
Wash each part for 1 minute in warm water.
•
Rinse well in warm water
•
If any residue is observed, repeat.
•
Air dry completely on a clean surface (e.g., clean paper towel or
clean drying rack).
•
Store dry parts when not in use.
•
Wipe down Pump Body with 70-90% ethyl or isopropyl alcohol
Note: Avoid touching the inside of any parts that may come in contact
with breast milk to prevent risk of contamination.
To Next Page
