WILMS KT 320 - Set up and Transport of the Unit

Set up and transport of the unit
Introduction: This section provides information required for:
unwrapping the unit
making it ready for use
transportation of the unit
Warning:
upright position for at least one hour before put into service!!!
Procedure: Follow these steps to unwrap the unit and make it ready for use:
1
on the top.
2
3
lying down.
4
screws.
Placing: Place the dehumidifier:
to ensure good air circulation.
front.
distance on the outlet air side should be 3 m.
• Away from any source of heat e.g. a radiator.
dehumidified.
If the dehumidifier has been laid down during transport, it is imperative to place it in
Step Action Illustration
Open the cardboard box
Place the box with the hand-
le and wheels on the
floor.
Pull the handle and wheel
of the dehumidifier out while
Loosen the finger screws
and pull the handle up and
tighten the finger
• In the middle of a room - if possible -
• Where air can be sucked in freely at the
back of the unit and blown out at the
• With a minimum distance on the supply air
side from a wall of about 60 cm. The minimum
In addition, ensure that windows and doors to the open are closed in the room to be
5