Wilo Z 15+ - Debugging and Menu Setting

Z 15+ - Timer Type Circulation Pump
Version 21.07
5
Please read over the operating manual prior to
installation and keep it for reference.
2. Debugging and menu setting:
① Time calibration: Adjust the time of water pump to the current time; press the “Time calibration”
key, the hour area starts flashing, press the “+/-” key to adjust the hours; press the “Run” key to
enter, the minute area will then flash, press the “+/-” key to adjust the minutes; exit the time
calibration function by pressing the “Run” key or not operating for 20s.
② Timing function: Set the running period of water pump; press the “Timing” key, the dial indicator
lamp becomes flashing, and press the “+/-” key to adjust the cursor to the target time period; (the
timer is based on the 12-hour system, and it automatically switches between AM/PM when the
cursor passes through the 12 o’clock) Press the “Run” key to turn on or off the current time period;
exit the timing function by pressing the “Timing” key or not operating for 20s.
③ Forced operation: Press the “Run” key, the set time goes off, and the water pump runs
automatically and continuously.