THE TWO POINT FIVE
CROSSOVER DESIGN PHILOSOPHY.
Music is in phase
, the two point five crossover
design is a common philosophical link between all
Wilson Benesch Loudspeakers. We have repeatedly
demonstrated that the phase coherence of reproduced
sound is a critical factor in high performance audio
systems. Integrity of phase from loudspeakers is a pre
requisite of sincerity. This approach requires the very
best components that are capable of coping with much
wider bandwidth than lesser systems could tolerate.
Hand built drive units provide for the highest levels of
precision. This level of precision allows us to realise
superior levels of performance that in turn allows us to
design the simplest of crossover networks that deliver
in phase energy to the drivers. These are also
manufactured by hand to obtain the shortest possible
signal path. Low grade PCB mounting systems are
avoided. The combined effect of this purist philosophy
translates into the most natural sound possible with
this design approach.
It is when the cable from the amplifier reaches the
loudspeaker that the Wilson Benesch standard of
engineering begins. Simplicity and quality is again the
order by which the signal quality is maintained.
Because we manufacture our own high quality
terminals we eliminate the superfluous. For this reason
finger tight connections are not even possible with
Wilson Benesch terminals. This air free method of
clamping is superior to all the alternatives accepted by
the conventional design. Soldered joints are used
throughout to maintain signal integrity and only
selected audio performance components are used. This
attention to detail is evident in all Wilson Benesch
components, It is this which makes the ultimate and
perceptible difference between Wilson Benesch
products and conventional audio products.
If its not in phase its not natural.
To Next Page
Loading...
