Installation
1. Pull up 4 clips according to arrow’s direction(Pic 1), making clips apart from the cover(Pic 2).
2. Holding main body, grabbed at an outlet pull upword, forcing the cover separate from the main
body(Pic 3)
3. If you do not need sponge, you can put other filter media as your requirement. After putting media,
it should be closed opposite direction as bottom filter board(Pic 4). Then put on the cover and
press it, then fasten four clips(Pic 5).
4. Put inlet to the cover, and put water pump to the bottom of the mian body. Screw these two inlet
and water pump(Pic 6).
5. Pls make sure the O-rings are at the correct position. And the switches are also at the correct
position(Pic 7).
6. 1
st
Method: Please connect green hose to the inlet and water pump when it used for the first time.
Forcibly suck the inlet hose. Let the inlet hose and bucket are full of water by siphonage. Then
install other spare parts(Pic 8). Attention ： the outlet hose must be immersed in the water while
absorbing water, and the bucket must below the tank water level.
2
nd
Method: put 3/4 water in the bucket, put the cover and turn on the power.(Attention: bring up
the filter in the same level of tank, then start work)
© by WilTec Wildanger Technik GmbH Seite 5
http://www.wiltec.info
To Next Page
Loading...
Need help?
General
