Need help?Do you have a question about the Wilton 4002 and is the answer not in the manual?
Details belt/disc size, motor, power requirements, and dimensions of the sander.
Covers eye wear, apparel, work position, guards, environment, accidental starts, and unattended operation.
Covers grounding, wiring, and wire size recommendations for safe operation.
Specific safety rules for operating the belt and disc sander.
Instructions for unpacking the sander and checking for missing parts.
Guidance on removing protective coating and waxing surfaces.
Steps for assembling the disc table and belt table.
Recommends securing the sander to a bench or table for stability.
Locates and describes the dust chutes for vacuum connection.
Specifies 115 Volts operation and checks before connecting power.
Details the importance and procedure for grounding the sander for safety.
How to turn the sander on and off using the switch.
Method to lock the switch in the OFF position for safety.
How to adjust the belt tracking for proper pulley alignment.
How to adjust the platen for proper belt support during sanding.
Procedure to set the belt table to a 90-degree angle using the positive stop.
How to tilt the belt table to a 45-degree angle for specific operations.
How to position the disc table at 90 degrees or tilt it down 45 degrees.
Steps to set a 1/16-inch gap between the disc and table.
Instructions for removing and replacing sanding belts.
Further steps for belt replacement, including directional arrows and tracking checks.
Procedure for removing old and installing new abrasive discs.
Aligning disc plate, adjusting guard, and reassembling disc table.
How to use the miter gauge on tables for angled cuts.
How to tighten a loose motor belt by adjusting the motor position.
Introduction to common sanding operations.
How to sand aluminum on the disc unit with the table tilted.
Method for sanding outside curves on the belt unit with platen removed.
Using an accessory felt belt for polishing operations.
Technique for sanding in confined spaces using the belt.
How to sand inside curves using the upper sanding belt idler wheel.
Information on how and where to order replacement parts.
To Next Page
General
