Wimius P60 - Install on the Ceiling

3 Support01@wimius.com
Install on the Ceiling
Keep the projector vertical and towards the mid of projector screen, keep the projection image flat on the screen.
1. To adjust the tilt base, unscrew the support rod at the bottom of the projector, see below picture.
2. For Ceiling mount, there are 4 holes at the bottom of the projector (M4*10mm). Please slowly unscrew the 4 black
rubbers, then you can find the holes for ceiling mount, see below picture.
Note: The hanging bracket or ceiling mount stand is not packaged.
Screw holes