Wimius P60 - Setting Up The Projector; Select The Input Signal Source

3 Support01@wimius.com
Rotate the focus ring or lens slowly. At the same time, check the focus point carefully. The best focus point for the
lens would be where the image most clear.
Note: If it is still blurry, please try to adjust the projection distance.
Digital 4D Keystone Correction
Use the digital 4D or 4P keystone correction of the projector to change the image to be rectangle(vertical and
horizontal). (see page 18)
Setting Up The Projector
The projector's home page is as follow:
Select The Input Signal Source
Select the desired input signal source (HDMI1/HDMI2/AV) on the home-page.