Need help?Do you have a question about the WiMo RANGER 811H and is the answer not in the manual?
General| Gain | 13dB |
|---|---|
| Impedance | 50 Ohm |
| Connector Type | SO-239 |
| Mode | SSB, CW, AM, FM |
| Input Power | 5 - 10 W |
| Voltage Standing Wave Ratio (VSWR) | 1.5:1 |
Initial checks after unpacking the amplifier before connecting.
Step-by-step guide for connecting the amplifier to the transceiver and antenna.
Steps for initial power-on and transceiver setup before tuning.
Detailed procedure for tuning the amplifier for optimal output.
Overview and function of each control on the amplifier's front panel.
Description of connectors and components on the amplifier's rear panel.
Key features of the Ranger 811H linear amplifier.
General introduction to the Ranger 811H amplifier's design and capabilities.
Description of the RF unit's Pi tank design for harmonic attenuation.
Explanation of the tuned circuit for harmonic suppression and input load.
Details on the three separate voltage supplies in the amplifier.
Technical specifications including circuit, frequency coverage, mains, drive, and RF output.
Description of the metering displays for plate, grid, and RF output.
Explanation of the LED indicators for operational status.
Description of the amplifier's cabinet finish.
Physical dimensions of the amplifier.
The weight of the amplifier.
Details of the product warranty and exclusions.
To Next Page