MANUAL CONVENTIONS
This manual uses the following conventions:
When we refer to key commands, the name of the key is enclosed in single quotes, e.g. ‘Esc’.
If a key command is incorporated into a sentence, where the name of the key has previously been
mentioned (in single quotes, to separate it from non-technical text) we will forgo the quotes.
When you must use several keys to activate a command, the keys have a plus sign between them,
e.g. ‘Ctrl’ + ‘Alt’ + ‘S’.
Command lines you must type in will be enclosed in quotation marks, don’t type the quotes
when you type the command.
Comments in the gray sidebars serve to draw your attention to special procedures, warning, or a
additional information. Especially important information is indicated by this icon:
To Next Page
Loading...