F6 Exits Setup without saving any changes
PAGE 1: STANDARD SETUP
Page 1 configures the basic system hardware. Most of the entries are defined by the hardware in
the computer. The entries must be the same as the hardware present. The chart on the next page
shows the items listed on the screen in the order they appear, with the default setting and the
options for each item.
Page 1: Standard Setup
MENU ITEM DEFAULT OPTION
System Time 00:00:00AM(PM)
System Date MM/DD/YY
Diskette A 3.5”, 1.44MB Not installed
Diskette B Not installed 3.5’, 2.88MB 3.5”, 1.44MB 3.5”,720K
1. 25”, 1.2MB 5.25”,360K
Hard Disk 1 Auto-detect Not installed User defined
Base Memory 640KB
Extended Mem. 3072KB
CPU Speed Fast Slow
Quick Boot Enabled Disabled
Boot Drive Order C:, A: A:, C:
Password Disabled
Boot Display Auto-detect Simulscan
Note: System Time is shown in 12-hour format, with hours, minutes, and seconds displayed.
System Date is shown with months, days, and years designated by either one or two-digit
numbers
Extended Memory will vary depending on how much system memory your computer has.
System Time & System Date
You can set the correct date and time in the “System Time” and “System Date” fields if the
current system clock setting is incorrect.
Diskette A & B
To Next Page
Loading...