Battery Low Suspend Disabled Enabled
Modem Ring Resume Disabled Enabled
Alarm Resume Disabled Enabled
Alarm Time 00:00
PAGE 3: ADVANCED SETUP
The Advanced Setup section of the Setup program is for additional hardware configuration
settings. These include settings for some of the optional hardware.
Page 3: Advanced Setup
MENU ITEM DEFAULT OPTIONS
Internal Audio Enabled Disabled
Audio IRQ IRQ7 IRQ5 Off
External Cache Disabled Enabled
COM Port 3F8h 2F8h 3E8h 2E8h Disabled
Internal Modem 2F8h 3F8h 2E8h 3E8h Disabled
LPT 378h 278h Disabled
PS/2 Pointing Device Enabled Disabled
HDD Block Mode Disabled Enabled
Note: Disabling the PS/2 pointing device disables both the internal and the external PS/2 devices.
Internal Audio & Audio IRQ
If you have either of the optional audio cards, you must set “Internal Audio” to “Enabled.”
You can use the default IRQ setting of IRQ 7 for the audio card, or you can select IRQ 5 instead.
IQ selection is explained in detail in “Audio System Setup Options” in Chapter Four.
Com Port, Internal Modem, & LPT
These settings for these entries are the standard address assignments used for these ports in IBM-
compatible PCs. The Internal Modem Port, which normally functions as COM 2, is reserved for
the fax modem even if you don’t have it installed. Do not change the addresses unless you have a
specific reason why you need to , and you know what you are doing. Normally, there should be
no need to change the.
PS/2 Pointing Device
This enables the built-in pointing device (either the trackball or the TrackPoint)
To Next Page
Loading...