Description: System controller failure.
Action: - Contact the Service Center listed on the “Read-Me-First” sheet that came with the
WinBook.
Message: Timer 2 failure
Description: System controller failure.
Action: - Contact the Service Center listed on the “Read-Me-First” sheet that came with the
WinBook.
Message: Keyboard controller clock line or data line failure
Description: The keyboard failed the self-test command.
Action: - Unplug external keyboard, if installed.
- Contact the Service Center listed on the “Read-Me-First” sheet that came with the WinBook.
Message: Keyboard controller stuck key failure
Description: Press ‘F1’ to continue.
Action: - Check to see if a key has actually become stuck.
- Refrain from pressing keys during boot process.
- Unplug any other PS/2 devices connected to the computer.
- Contact the Service Center listed on the “Read-Me-First” sheet that came with the WinBook.
Message: Diskette drive failure
Description: The floppy controller failed to respond to the reset command.
Action: - Check system Setup by pressing ‘CTRL’ + ‘ALT’ + ‘S’.
- Turn off the system and check relevant connections.
- If the problem persists, you may need to replace the floppy drive, or contact the Service Center
listed on the “Read-Me-First” sheet that came with the WinBook.
Message: Pointing device failure
Description: The pointing device does not respond during the power-on self-test.
Action: - If external PS/2 device is plugged in, unplug it.
- If external PS/2 pointing device is plugged in, it must use duplex adapter.
- Try re-installing the pointing device.
To Next Page
Loading...