Trampoline
1. Slide trampoline into track on side of hull, with pointed corner forward and seat strap in
center of trampoline on the top side.
2. Shackle pointed corner of trampoline to stainless eye strap at front of track.
3. Use short piece line to stretch back inside corner of trampoline aft to stainless pad eye,
and pull bolt rope very taught. This line will remain secured during use and storage.
4. On each outboard corner, tie a 60” piece of line to the ring
using a bowline. From the ring, lace over the crosstube and
through the inboard fairlead, back through the ring and over
the tube and through the second fairlead, back through the
ring and back to the jam cleat.
5. Soft seats are available from WindRider that clip to the rings provided on the trampolines
and provide extra comfort for your passengers. See your WindRider dealer for this
accessory.
Adjusting your Phase3™ rear seat
To raise the seatback on your rear seat, pull the orange ball found on
the front of the seat (between your thighs) forward and slide the barrel
lock along the line to hold it in position. To lean the seat back fore and aft,
adjust the webbing strap found on the starboard side of the seatback
(under your right elbow when seated. Your thigh support may be moved
up or down by adjusting the webbing straps found on either side of the
thigh support.
Moving your front seat
The front seat is designed to be removable, so it can be used facing either forward or aft, or
removed completely to make more room for gear. To move your seat:
1. Push the front bottom of the seat back, which will flex the plastic enough to release seat
from retainer on the cockpit floor.
2. Carefully lift the front of the seat and disengage the back of seat from its retainer and
notch.
3. To re-install seat, reverse this process.
To Next Page
Loading...