20
Operations
4. Tip machine back by main handle to move to
starting point.
5. Lower machine to floor.
6. Select intermittent or continuous switch setting to
turn on brush and start solution spray.
The intermittent setting requires the operator to
hold the switch in the "on" position with the thumb,
and is typically used in small areas where short
cleaning passes are made.
The continuous setting allows the operator to set
the switch in the "on" position with one touch, and
is typically used in large areas where long cleaning
passes are made.
Cleaning Procedure
1. Start at wall closest to power outlet. Pull straight
back without pushing down on handle.
86401410 Operators Manual - Cadet 115V
To Next Page
Loading...
