33
Maintenance
Pushing Machine
The machine may be pushed for short distances at
speeds not to exceed 5 mph. Be careful to avoid
damaging machine. The machine may be pushed by
hand from the rear.
NOTE: To avoid damage caused by regenerative
voltage, disconnect traction motor before towing or
pushing machine.
Machine Tie-downs
There are two tie points located at front and each side
of foot box frame and two at the front side of frame.
Tie-down devices must be of the proper type and
strength. The combined strength of all tie-downs must
be strong enough to lift two times the weight of the
machine. Tie-downs must be positioned to prevent the
machine from moving forward, backward, or either side
to side. Use all four corners of the machine with the tie-
downs running out opposite directions. Tie-downs must
be attached to the transporting vehicle securely.
Preparation for Loading/Unloading Trailer
Before loading or unloading machine from trailer, brush
head must be in the up position before loading.
NOTE: When transporting the machine on a trailer or
in a truck, in addition to using tie-downs, be sure to
set the parking brake, and block the tires to prevent
the machine from rolling
86347810 Chariot iVacuum 34
To Next Page
Loading...
Need help?
General
