Windsor LB1500 - User Manual

Questions and Answers

S
stewartcherylAug 11, 2025
What to do if my Windsor Floor Machine will not run?
- R
  Ryan RivasAug 11, 2025
  If your Windsor Floor Machine won't run, there are several potential causes. First, check if a circuit breaker in the building has tripped and reset it if necessary. Another possibility is a power switch failure, in which case you should test the switch for continuity and replace it if needed. Also, check to see if the fuse in the motor is blown and replace it. Use caution and unplug the machine before opening the fuse holder. Remember to investigate the cause before replacing the fuse, as it typically only blows under extreme conditions. Finally, a faulty power cord could also be the culprit, so consider replacing it.
T
Timothy FloresAug 17, 2025
Why does my Windsor Floor Machine keep tripping the circuit breaker?
- G
  Grant JonesAug 18, 2025
  Repeated circuit breaker tripping in your Windsor Floor Machine usually indicates a mechanical problem causing higher amp draws. Find and fix the mechanical issue before using the machine. It could also be due to a faulty circuit breaker. Test the circuit for continuity and replace the circuit breaker if necessary.
J
Jesse CollinsAug 25, 2025
What to do if I get an electrical shock from my Windsor Floor Machine?
- R
  Rodney HendricksAug 25, 2025
  If you're experiencing electrical shock from your Windsor Floor Machine, immediately ensure the equipment is properly grounded by following the grounding instructions exactly. Also, have an electrician inspect the building’s wiring to confirm the receptacle is grounded. An internal wiring problem could also be the cause, so ensure that the machine wiring matches the appropriate wiring diagram and replace any wires or components that are short-circuiting.
M
Melissa ReeseAug 29, 2025
Why is my Windsor Floor Machine vibrating excessively?
- R
  Richard DodsonAug 29, 2025
  Excessive vibration in your Windsor Floor Machine can stem from a few issues. Check if the pad is centered and re-center it if needed. A damaged or unevenly worn pad can also cause this, so replace the pad, and remember not to rest the machine on the pad when not in use. Lastly, a damaged pad driver could be the problem, so consider replacing it.
S
Sandra RodriguezSep 4, 2025
What to do if the pad does not turn on my Windsor Floor Machine but the motor is running?
- D
  David ShannonSep 4, 2025
  If the pad on your Windsor Floor Machine isn't turning but the motor is running, the belt is likely loose or broken. You should adjust or replace the belt.