Windsor passport - Operating the Passport Extractor; Using Accessory Tools; Maintenance Schedules; Daily and Periodic Maintenance

OPEUTING THE P.GSPORT
OPERATtvG THE P.GSP0RT WITH
ACCESSORY TOOLS
NOTE: Vacuum the cvpet md make axe it is c!d of
surface dcoris before clevling with the PASSPORT. Venalatc
aru aft^ cvpet has been ciuncd. Keep chiidren and pers"
away and do not waik on cvpct unul it is dry.
MTE: .-ch s& rciieilcord retainer
to the pwe: cod
1.
Wake a loop in power cord
approximateiy !2" from nvist
lock reczptac!e end.
Slide cord loop through slot in.
recunc: am. Full slat& cord back
mna to handle.
2
&rough slot to secrm. AKach
Adjusr brush hcighf by mg knob at
front of Sacbine. Pointer on left side
indicves urpe: hcghr.
LOW - 114 incS
MED - 1/1 inch
HIGiI - 1 cinch
XOTE: Incorn: brush height may cause cimit breaker
to trip. Rase brush and reset drdt bder..
3.
4.
Turn soluaon valve to "CARPET CLUMNG" posiaon.
P!up power cord into a grounded wall outlet.
WARVIIVG! Defeating the grounding pin on the power cord
a result in a severe eiececd shock
5.
6.
TLEI on the vacuum switch and bmsh switcS.
Deiress intermincat pump smtch to dispense cl&g
solution.
FliI in3Ciline backwards
Rekse ;rump switch about 11, inches before the end
of ezcn c!eming pass. Ttus will ensure all cluning
solurion is vac~umed from cypet
C.UTION: While openting mchinc.. check for CKC&VC foam
build-up in the recovery tank. If excessive foam is present, add o
ddomer solution to recovery tank.
7.
€spry recovery tank when approximately 34 full.
C.lLTON: Do not w the recovery tank to GU the roiution
tank. u&ss it is CLEhN. Sediment in the recovery tank
an damage the soluaon pump and clog the spray jets
rendering the macfiine inopenblt
8. Venuhc arm after cvpet has been C~UIXCL
PROTECT FROM FREEZGVG
If it becomes necessary to store in tempencum that could drop below
LO F. the pumping system. hoses md vdva must be pmcd from
tizccq with i methyl hydntc window washe: antifraze soluuon.
NOTE: Do not xse erhyiene glycol or cooling system mtifrcezcs.
1.
Add a gallon or two of window washer mtifmze to the supply
t-. rum on pump switch md spray until the mtifmte solution
ilils :he solution lines.
Dan out the !eftover mifreeze from the supply tmk. Always
dIow :he unit :o rcxh mom tcmpcnnrres before filling with
hot WXC: or opcr3ung.
Z
The P.4SSWW is eyily adapted for use wirh the following
Windsor jcczssoory tools: DHT-UPEU.SW3'FWSW/PRO
1.
2.
3.
A
5.
Turn solution valve to ".4ccessorp TooP position.
Rcmovc recovery hose from dome md insen vacuum hose
for 3etrsory cooi in ia piac:.
Att3ch soluuon hose from accssory tooi to brass soluaon
Ripple on lower bad of chassis.
Makc sure that solurion tank has ciuning soluaon and chat
movery tank and dome arc in piae md ready for opmaoh
Switch on PASSPORTS Vacuum and Continuous switches
O~Y. Use jcctasop tools Y with md Standard wmctor.
WARNING: Do not switch on brush switch when operating the
madline with 3cc~so~ tools. Cqer damage may occur.
6.
MaLc sure that the solution vdve is returned to the met
Spray" Fsiuon before using the machme 3pn for self-
contained cqe: cidng.
WARNING.' Before m&ng my adjustments or rc?iun to the rnacfime.
~~SCOMC~ the ?owe: cord from tiec:ncd jourc:.
1.
Z
3.
1.
hpty unused cievlrng soluuon from the solunon mic.
Inspet: and cim ater screen m solution tyllc
Run pumping system with i or 2 gjilons of :!em. hot watc.
After~ah use. arise tank with fresh wxe:. Pezoaicdly
inspec: ihe recovery tank and decontaminate if necrsary.
using i Hospitd Grade Viruadc or i 1 - 10 bleach to watcc
solutlon Waste water should be Oisposd of properly.
5. CSeck for md emove my lint or debns around brush and vac shoe.
6. 0:cX jpny jes for full spr3y pattern.
7. Remove !int and din buiid-ip from brush 3nd housing.
NOTE: Always ston ma&ine with brush in "StoR:' p~siti~n.
PERIODIC .XADTEN.LVCE
TWIC: 1 month. flush a wnne vinenu soluuon (One quart vinegar
to two gllons of ware:) or mu - browrung solution (mixed IS
dirmed) hu3h the exmc:or. This will preve3t build-up of
ahiinc residue in the syscem.
If spny jcrs become clogged. remove the spny tips. wash them
thoroug!Ily, md blow dry.
NOTE: Do nor use pins. wire. e~. to cfcm norz!a Y th~s could damy
spray panm.
If spn~ Jes drip 3itc: :he pump is turned off. solenoid vdve may
need :o be :!euled.
Apply silicone luhncvlt to sciution rucpie.
Penodtcdly :nscec: dl hoses. c!ccmcd cables. tilten mnd con-
nec:ions on your machine. Fnyed or czcked hoses should be
re?ared or :tpl;lc:d to e!iminate vac.Jum or solution pressure
loss. Scc;usc rhc c!ec:ncd able must be well insulsted md c:
C0Mef:of sc:ews key tight. If the ;sole insulsuon IS broken 01
hyed. mar or :c?isc: it :mncdiate!y. Don': t3kc ch~c~ wrth
c!e~:ccd 3r: or shock.
4