Windsor SENSOR S12 Maintenance Guidelines

9
Upright Vacuum
Call: 1-800-USA-CLEAN (800-872-2532) Click: www.usaclean.com Fax: 1-888-USA-CLEAN (888-872-2532)
Windsor Sensor
Replacing the Power Cord and/or Switch
These are general maintenance guidelines.
Please consult your owner’s manual prior to performing any repairs or maintenance on this machine.
**Before you begin: Turn the machine off and unplug it.
8. Using a Phillips
screwdriver,
remove the 2
screws holding
the power cord
bracket.
9. Using a
small Phillips
screwdriver,
loosen the 2
screws holding
the black wires.
You do not need
to remove these
screws, just loosen
them.
10. Slide the black
wires out.
11. Pull to
disconnect the
wire connectors
attached to the
switch.
12. Push the
switch fom the
back of the handle
to remove it.
Note: You may
need to use a
small at tip
screwdriver to
gently push the
switch through the
handle.
13. The front
switch cover will
come off when you
push the switch
through (step 12).
14. Reverse the
process to install
a new power cord
and/or switch.
Refer to step 1
to reconnect the
wiring correctly.

Windsor SENSOR S12 Specifications

General

Brand	Windsor
Model	SENSOR S12
Category	Vacuum Cleaner
Language	English