EasyManua.ls Logo

Windsor SENSOR S12 - Filter Level Indicator System; Brush Control System

Windsor SENSOR S12
10 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
A Filter level indicator
B Brush controller
Filter level indicator
The red warning light (A) indicates a blockage or
a full bag,
so
check:
a)
Is
the dust bag full?
b) Is there a blockage in the hose or power
head?
If the red light is disregarded the machine will
shut
off
and the light will flash.
Brush controller
The electronic brush controller continuously
monitors the operation of the brush.
If the red light
(B)
stays
off,
the operation of the
brush is correct.
If the red light
(B)
turns on in positions
1
-
4
of
the Pile adjustment knob adjust the brush by
turning the Pile adjustment knob to a lower
position.
If the red light
(B)
burns continuously in the
position
1,
the brush must be changed for a
new one.
If
the machine turns
off
and the red light
(B)
flas
-
hes, the brush has become blocked and is not
turning. Switch the machine off, unplug it from
the mains and clear the blockage.
If there is no blockage, and machine turns
off
with brush light flashing, raise brush to a higher
position.
When the machine is switched on in the upright
position the brush automatically rises from the
carpet. To release the machine from the upright
position, press down the foot pedal
(19).
The
brush will automatically lower. The handle can be
lowered to an intermediate stop position in order
to lift up the brush head. To lower the
handle to a horizontal position, the foot pedal
must be pressed a second time. The stop positi
-
on can be closed off by a slider on the swivel
neck
(25)
so
that the handle will go from vertical
to horizontal in one movement.
To vacuum in corners etc.:
take hold of the telescopic handle grip, lift, it
away from the machine and stretch out the hose.
After use insert the telescopic attachment tube
into the back of the machine. Raise the handle of
the machine and the hose will automatically
retract. To use the hose without the tube as
shown in the right hand picture, the hose will pull
out of the tube while the tube is fitted to the
machine. Alternatively, press the release catch
(27)
on picture
2.
To vacuum under beds etc., the machine can be
fitted with an additional straight tune and the
floor nozzle. The machine will then perform as a
cylinder vacuum.
Never run over the cable with the brushlsuc-
tion head.
Always carry the machine over steps and sills.

Other manuals for Windsor SENSOR S12

Related product manuals