N
ncraneAug 13, 2025
What to do if Winegard SK-1000 Trav'ler is not receiving 99 and 103?
- JJohn AdamsAug 13, 2025
Ensure that the B-Band Converter is installed for your Winegard antenna.
To Next PageTo Next PageWhat to do if Winegard SK-1000 Trav'ler is not receiving 99 and 103?
Ensure that the B-Band Converter is installed for your Winegard antenna.
What to do if Winegard Antenna shows stow failure and is not stowed?
If your Winegard TRAV’LER antenna is not stowed, avoid moving the vehicle. Attempt to stow the antenna again. If it continues to fail, inspect for any obstructions.
What to do if Winegard SK-1000 Trav'ler Antenna displays NO LNB VOLTAGE?
If your Winegard TRAV’LER antenna isn't receiving the necessary 12–18 VDC to power the LNBF, verify the coax connections. If the connections are secure, further assistance is needed.
What to do if Winegard SK-1000 Trav'ler shows stow failure stow unknown?
Check the data cable connection on the back of the Winegard TRAV’LER interface. Ensure it is properly connected.
Why Winegard SK-1000 Trav'ler Antenna AZ motor stalled?
The AZ motor might be stalled because something is preventing the Winegard TRAV’LER mount from rotating; check for obstructions.
Why Winegard Antenna EL home failure?
The Winegard TRAV’LER mount is unable to find the HOME position because something is preventing it from raising. Check for obstructions, especially if the unit was recently manually raised or the electronics were replaced. The calibration may need to be reset.
Why Winegard SK-1000 Trav'ler Antenna EL motor stalled?
The EL motor might be stalled because something is preventing the Winegard TRAV’LER mount from raising or lowering; check for obstructions.
Why Winegard SK-1000 Trav'ler SK motor stalled?
The SK motor might be stalled because something is preventing the Winegard TRAV’LER reflector and LNBF from rotating; check for obstructions.
Key physical and performance metrics of the antenna system.
Important precautions to avoid damage, injury, and warranty voidance during installation.
Details on necessary space and obstructions around the antenna for safe operation.
List and visual identification of all components included with the TRAV'LER antenna.
Guidelines for selecting optimal mounting and cable entry locations on the RV.
Detailed steps for physically mounting the antenna base onto the RV roof.
Instructions for installing the cable entry plate and connecting cables.
Diagram illustrating the complete system connection from the roof mount to the receiver.
Instructions on how to attach the satellite dish reflector to the antenna mount.
Details of the product warranty terms, coverage, and claim process.
Step-by-step guide for automatic satellite acquisition for DISH network users.
Instructions for manually setting the antenna to find specific satellites.
Step-by-step guide for automatic satellite acquisition for Bell TV network users.
Configuration steps for common DISH receivers to work with the TRAV'LER antenna.
Procedures for properly stowing the antenna before moving the vehicle.
Method for manually stowing the antenna in case of power failure or malfunction.
How to quickly disable power to the antenna in emergency situations.
Additional information regarding environmental factors and signal reception.
Common issues and their solutions for the TRAV'LER antenna system.
General