SECTION 10
PLUMBING SYSTEMS
10-14
2. Set the machine to fill on regular cycle and
WA RM was h.
3. Turn the machine On for a few minutes so it
can take in any water left in the hoses. (Lift
the hoses at this time to be sure no water is
trapped in low spots of the hose.)
4. Turn the machine off.
5. Advance the wash time to SPIN cycle and
turn the machine On to pump out as much
water as possible.
6. Turn the machine Off again.
7. Place a bath towel or shallow container
beneath the drain/lint filter door on the lower
front of the machine to catch water. Then
remove the filter to drain any water left in
the bottom of the machine.
8. Reinstall the filter correctly to assure that it
does not leak water.
9. Optional - If you wish to add RV antifreeze
to ensure safety of the washer pump, add
about a gallon of non-toxic RV water system
antifreeze to the washer drum and rerun the
SPIN cycle to fill the pump and lower cavi-
ties with the solution.
10. Turn the machine off.
Washer/dryer winterizing is now complete.
NOTE: Remember to reconnect the washer
supply hoses when placing the washing
machine back into service. Then run the
machine through the fill/spin cycle (steps
2-6 above) to remove and rinse the RV
antifreeze from the machine.
To Next Page
Loading...
Need help?
General
