To Next PageTo Next Page
Need help?Do you have a question about the Winterhalter Gastronom GS 650 and is the answer not in the manual?
General| Brand | Winterhalter Gastronom |
|---|---|
| Model | GS 650 |
| Category | Washer |
| Language | English |
Controls for switching the unit on/off and for tank drainage/self-cleaning.
Indicators for faults, detergent/rinse additive levels, and water treatment.
Displays for boiler and tank temperatures during operation.
Buttons for selecting wash programmes like normal, short, intensive, and rinse.
Buttons for activating and selecting special programmes.
Describes the automatic programme steps: washing, dripping off, and rinsing.
Explains how detergent and rinse additive are supplied to the machine.
For normally soiled items with medium drying time.
For lightly soiled items with short/no drying time.
For heavily soiled items with long drying time.
For items with protein-containing soiling, prevents coagulation.
Automatic cleaning of the machine, pumps off dirty water and rinses.
Turn on water stop valve and switch on customer's main switch.
Check and refill rinse additive and detergent containers for automatic dosage.
Verify that flat filters, basket filter, and drainage filter are correctly installed.
Press On/Off switch; observe programme button lights for heating status.
Instructions for scraping, placing, and arranging wash items in the racks.
Close door, select programme, and press the programme button to start.
Check basket filter, tank water, and leave door open for drying after washing.
Press the '+' button to activate the special programme selection area.
Press programme buttons for short or intensive programmes as needed.
Select desired programme by pressing the relevant button; previous selection is cancelled.
Press the '+' function button to deactivate special programmes and return to normal.
Initiate cleaning programme; machine pumps off dirty water and rinses.
Remove wash items, clean filters, leave door open for drying.
Turn off water stop valve and customer's main switch to ensure safety.
Remove and clean basket filter, flat filter, wash arms, and drainage filter.
Clean outer walls with special stainless steel cleaning products.
Steps for descaling the machine using an intensive programme and descaling solution.
Faults are indicated by symbols and error codes on the display.
Table of common faults (e.g., not starting, not clean) and their remedies.
Explains error alarms via programme key 6 and alarms for optional extras (ECO, DOS).
Workplace related emission value measured according to DIN EN ISO 11202: LpAeq < 70dB.
