24 25
6.3 Change default start time
The default start time of 9:00 can be changed to anytime by keep pressing “START”
and “OK” buttons at the same time for 3 seconds. When the first number is flashing
on the display you can use “START” and “HOME” buttons to select the new start
time and press “OK” to confirm. If “IDLE” will appear on the display and you hear
a beep, the new start time is correctly set.
6.4 Change default Mowing time per day
The default cutting time is 8 hours per day, you can change it to 1-24 hours. Press
“OK” button for 3 seconds, when the first number will flashing on the display use
“HOME” and START” buttons to set a number from 1 to 24 and set how may hours
you want your lawnmower operate in your lawn. Press "OK" to confirm. If "IDLE"
appear on the display the new working time is correctly set.
6.5 Change default mowing time per week
The default cutting time per week 5 day, you can be change to 3 or 7 day, keep.
Press "HOME" and “OK” buttons for 3 seconds, when the first number will
flashing on the display use “HOME” and START” buttons to set a number
from 03 to 07 and set how may days per week you want your lawnmower
operate in your lawn. Press "OK" to confirm. If "IDLE" appear on the display
the new working time per week is correctly set.
Function and Error messages self-checking list
1. Turn lawnmower off.
2. Take lawnmower to an area in your lawn free of
obstacles.
3. Turn lawnmower on. Press START then OK.
4. If the error message is still displayed; turn power off
turn lawnmower upside-down. Check if there is something
preventing the front wheels axle sliding.
5. Remove any obstruction, turn lawnmower upright,
power on. Press START then OK.
The lawnmower is lifted up
1. Turn lawnmower off; take it to an area free
of obstacles.
2. Turn lawnmower on. Press START then OK .
3. If the error message is still displayed, turn power
off; turn lawnmower upside-down and check if there
is something preventing the wheels from
4. Remove any obstruction, turn lawnmower
upright, turn power on. Press START then OK.
1. Turn lawnmower off.
2. Turn lawnmower upside down and check if
there has something preventing the blade disc to
rotating.
3. Remove any obstruction.
4. Turn lawnmower upright and take it to an area with
short grass or adjust the cutting height.
5. Turn lawnmower on. Press START then OK.
1. Turn lawnmower off.
2. Take lawnmower to an area in your lawn free of obstacles
3. Remove the floating cover and check the cylindrical
magnet on the floating cover. If there is no magnet
replace the floating cover.
4. Turn power on. Press START then OK.
11
No Boundary signal
1. If robot is inside working area and charging
station LED light is RED, it means that the
boundary wire was not well connected to the clamps
on the charging base. If it was well connected to
the clamps and the LED light still turns RED, check
whether the boundary wire is interrupted.
Wheel motor blocked
Blade disc blocked
Obstruction sensors trigger not
recovered
F1 Rain delay activated No action is required.
lawnmower outside working area
1. Check whether the lawnmower inside the working area,
if it was.
2. Check whether the charging base is properly
connected to charger and that it is connected to a
suitable power supply, if they are properly connected,
the boundary wires are clamped incorrectly and must be
reversed.
EN
To Next Page
Loading...