26 27
Rollover sensor has been triggered
1. Check the battery temperature. the temperature is
too high, wait until the temperature has cooled down.
if the temperature is too low, wait until the temperature
>5 centigrade, Press START then OK .
2. If the error message is still displayed, replace with a new
battery. Restart lawnmower.
If the error repeatedly occurs, contact after sales service.
1. Turn lawnmower upright. Press START then OK .
BP
Battery pack
temperature protection
Error unknown
1. Restart lawnmower. Press START then OK. If the
error message is still displayed, contact a service agent
for help.
1. Check the Boundary wire on each side of the charging base
should be straight for 1m without corners or obstacles to
ensure proper docking.
2. The charging station must be positioned on relatively level
ground. it must not be positioned on an inclined surface or
anywhere that makes its plate bend.
3. Manually dock lawnmower in the charging base for
charging. After lawnmower is fully charged, Press STAR
then OK.
Tilt sensors has been triggered
1. Turn lawnmower off.
2. Take lawnmower to a flat ground in your lawn.
3. Turn lawnmower on. Press START then OK .
Charging docking unsuccessful
The software can be updated when new versions are available. Please contact your
dealer to know if there some new firmware for your robotic lawnmower.
Your lawnmower works hard and needs to be cleaned and checked from time
to time. Some parts will require replacement as they become worn. Switch off
the machine before carrying out any service or maintenance. Here's how to take
care of your lawnmower.
9.1 Keep it sharp
WARNING: Before cleaning, adjusting, or replacing the blades, turn your
lawnmower OFF and put on protective gloves.
WARNING: When fitting new blades, make sure you replace all the blades. It’s
not mandatory to replace all screws if they are in good condition, if the screw has
been damaged or unable to be fixed, then need new screw for mount the blade.
This is important to ensure blade retention and balance the blade turning disc.
Failure to use new screws could cause serious injury.
Each cutting blade will last up to 2 months when it is programmed to mow
everyday. Always check to see if the blades are chipped or damaged and replace
them if they are. When the cutting blades are dull and worn out, they should be
replaced with the spare blades provided with lawnmower. Spare blades are also
available at your nearest retailer.
Before attempting to replace your lawnm
ower blades, turn the power off and
put on protective gloves.
IMPORTANT: After screwing the blade to the blade disc, make sure the blade is
able to spin freely
9.2 Keep it clean
WARNING: Before cleaning, turn your lawnmower OFF. Put on protective gloves
before
cleaning the blade turning disc. Although your lawnmower is waterproof, it
is preferable never to use water to clean it. Use compressed air and a brush to clean
the lawnmower.
EN
To Next Page
Loading...