Need help?Do you have a question about the WIRTGEN Hamm 3518 P and is the answer not in the manual?
Provides technical specifications for a specific model, H180 3412 HT.
Details specific operating elements, switches, and their functions in the control stand.
Explains the designation and key features of the Deutz engine drive unit.
Shows a diagram of the engine's lubricating oil system.
Details the electronic control system of the Deutz engine.
Describes the engine temperature sensor and its characteristics.
Explains the combined sensor for charge air temperature and pressure.
Details the fuel low-pressure sensor and its specifications.
Describes the camshaft speed sensor and its resistance.
Details the crankshaft speed sensor and its resistance.
Explains the engine oil pressure sensor and its measuring range.
Illustrates and labels the fuel system components in the engine compartment.
Shows an example fuel diagram for the TCD 2012 engine.
Details the fuel prefilter assembly and its parts.
Explains the fuel filter assembly and its components.
Describes the SEPAR filter, an optional fuel system component.
Details the fuel fill level sensor and its characteristic curve.
Illustrates and labels air filter components and maintenance procedures.
Shows a diagram of the coolant flow for the Deutz TCD 2012 engine.
Details the engine cooler assembly and its operating parameters.
Explains the engine coolant level sensor and its pin assignment.
Illustrates the hydraulic oil cooler and its specifications.
Diagrams the hydraulic system for tilting the engine hood.
Details the manual pump used in the tilt hydraulics system.
Explains the variable displacement pump for the drive system.
Details the variable displacement pump for vibration systems.
Illustrates the wheel gears and drum drive mechanism.
Details the variable displacement motor for the drum drive.
Explains the variable displacement motor for the axle drive.
Details the vibration motor and its installation notes.
Provides instructions and warnings for towing the machine.
Details the computer units and control modules for the HT system.
Lists error codes and their possible causes for the MC6 controller.
Provides troubleshooting steps for various error messages.
Lists error codes 205-338 and their corresponding locations.
Lists error codes 401-999 and their corresponding locations.
General| Brand | WIRTGEN |
|---|---|
| Model | Hamm 3518 P |
| Category | Construction Equipment |
| Language | English |
To Next Page