1)
2)
3)
The pressure switch is the most suitable for simultaneous use of pressure indication and switching.
It can be used for explosionproof or hazardous area.
A micro switch is useful for stable open or close due to its snap action.
This is a pressure and differential switch equipped with a micro switch.
The switch is composed of pressure sensor, setting value and incoming pressure controller, and contact output micro switch.
Before you use this product, please read through this manual for correct use of each device.
1. Introduction
On reaching a set pressure, this product can be used for process control, abnormality notice, or warning on the basis of the On/Off signal.
In addition, due to the pressure resistant and explosionproof structure, it can be installed in explosionproof areas.
2. Application
We are not liable for any damage or failure of this product which was caused by your own modification, change, or repair against this manual
and the warranty will be no longer valid.
4. Warranty
3. Features
04
To Next Page
Loading...
