1. Open the battery compartment cover.
2. Insert 4 LR6 (AA) / 1.5 V batteries facing in the
direction indicated on the bottom of the battery
compartment. Make sure that the poles of the batteries
are correct (+/-).
3. Put the battery compartment cover back in place and
close it.
Starting atomic signal reception
As soon as the clock has power from the batteries, it
begins receiving and searches for the WWVB signal. If
the time signal is been received in sufficient strength,
the date and time are shown on the display.
You can choose atomic signal reception ON/OFF in the
setting mode. Default is ON.
When OFF is set, the atomic signal automatic reception
is turned off permanently.
The clock will search for the atomic signal at 1:00AM, 2:
00AM, 3:00AM, 4:00AM, and 5:00AM every day.
• If there is no WWVB reception, the clock will search
To Next Page
Loading...