Installation Manual
21
DOOR DETECTOR MODEL:
WSE EVO
WSE EVO SLIM
5. Packing list
Manufactured under ISO 9001
1. Installation (fig. 1)
1.1) Securely fix the transmitter and receiver to the car or the car doors through the fixing holes with the
bolts provided. Please ensure that the labels are pointing outwards.
1.2) Ensure that both the receiver and the transmitter are aligned correctly.
1.3) Connect the cables from the receiver and the transmitter to the input terminals of the door controller.
1.4) Ensure that both cables can bend easily.
1.5) Connect both sides of the intermediate connectors.
1.6) Switch on the power.
The yellow LED in the receiver will now light up.
The red LED in the receiver will light up when the infrared beams are interrupted.
3. Troubleshooting
3.1) Neither of the LEDs in the receiver are lit.
The cable is broken or not connected.
3.2) Both the yellow and red LEDs are lit without interruption between the RX and TX (fig. 5).
The plastic filter is too dirty.
Other infrared equipment is nearby.
The ambient light is stronger than allowed.
There is a system fault.
3.3) The LEDs are lit correctly when interrupted, but the car door doesn’t open.
Wrong connection with NC/NO contacts.
The output relay is broken.
Check the wiring.
LEDs in RX
Yellow
– Power indicator
Red
– Status indicator
4. Notes on handling
Keep the connection cables away from high voltage and/or high current wires.
Keep the connection cables away from the door motor and door drive.
Avoid direct sunlight or other infrared ingress to the receiver (RX).
Prior to power-on, clean the lenses with a soft, damp cloth.
Do not bend or twist the edges and do not scratch the lenses.
Planned Maintenance Procedure
Ensure that the yellow LED is lit (system functioning). Clean the lenses with a soft, damp cloth. Check
all of the plug and terminal connections. Perform a detection test by inserting an object greater than
50mm between the TX and RX. The red LED status indicator will light up to confirm object detection.
2C. Connection diagram for power supply box (fig. 4)
fig. 4
fig. 5
Power supply model 03.G5.PWS.UBX
fig. 1
Quantity
1 copy
1 set5
1
2
Items
Connecting cable
Transmitter Mounting accessories1 piece
Items
3 Receiver 1 piece
Quantity
4 Operation manual1 set
For Elevator Use Only!
fig. 2
2B. Connection diagram ECO+/MIDI+/SUPRA
door controller and parameter set xE (fig. 3)
For boards without EN 81-20 setting, use the
yellow wire instead of the green one.
fig. 3
2. Wiring
2A. General connection diagram (fig. 2)
PM.9.004895.EN – 2019.05.09 V1
To Next Page
Need help?
General
