Mixer cleaning starts.
Duration 30 seconds.
Plug&Clean cleaning
starts.
Duration 2 minutes.
Machine cleaning starts.
Duration 8 minutes.
Step 6 and 10: Only if beverages containing milk have been previously prepared.
Step 9: Only if beverages containing choc components have been previously prepared with the optional mixer.
Manual combi spout cleaning Switch off using the ON/OFF button prior to cleaning. Unplug mains plug.
A
B
Caution!
Carefully disconnect
the milk hose.
Pull forward the lever behind the
combi spout
Remove combi spout
Remove milk hose from milk
container and release from
combi spout
If a mixer is fitted:
Release the mixer hose
Mix 5 ml of WMF Special
cleaner with 0.5 l of warm
water
Dismantle combi spout
Immerse one end of the milk
hose in the cleaning solution
Immerse the length of the
remaining milk hose in the
cleaning solution
This procedure prevents air bubbles
from remaining in the milk hose.
Soak all parts of combi spout in
the cleaning solution
All parts must be completely
immersed.
After 5 hours clean all parts
thoroughly with a brush
C
Rinse combi spout and milk
hose very thoroughly with clear
water so that no cleaning fluid
remains
If a mixer is fitted:
Rinse mixer hose thoroughly
Reassemble combi spout
Replace combi spout
Insert milk hose
If a mixer is fitted:
Insert mixer hose
Instructions
Foamer cleaning:
See the flip-side under “foamer cleaning” for interim cleaning.
Manual combi spout cleaning with Plug&Clean:
Perform at least once per week.
Manual combi spout cleaning without Plug&Clean:
Perform at least once per day.
After Plug&Clean cleaning:
The cleaned milk hose can be stored with the adapter in the closed
cooler.
To Previous Page
Loading...
Need help?
General
