WMF KULT X - Hob Functions and Operating Procedures; Control Panel Functions Explained

17
en
Functions
Touch control panel (3)
The double induction hob has two hotplates. You can use the two touch control panels (3) to set the
two hotplates independently.
The functions of the induction hob are activated by tapping the corresponding symbol buttons. The
control panel reacts to being tapped lightly without needing to apply pressure. To work correctly,
the control panel has to be clean and dry. The corresponding LED lights up red when a function is
activated, e.g. after switching the appliance on.
Display (9) Direct select programmes (8)
Set timer (10)
Power level setting (7)
On/Off (5)
Power-Sharing (12)
Setting power levels (7)
The appliance has eight power levels that are set and changed directly through
the power level controller and displayed correspondingly through the red LEDs.
If you touch a position on the power level controller, the corresponding level is
selected. All LEDs from the lowest level (left) to the selected level are then lit. You
can also change the selected power level by sliding your finger from left to right,
or from right to left along the power level controller.
Display (9)
To show the timer. The timer can be reset any time by using the + and - (10)
buttons.
Set timer (10)
The timer is set through the + and – (10) buttons. If you tap on one of the but-
tons, the time is changed by 1 minute. If you tap and press one of the buttons for
a longer time, the time is changed progressively in 10 minute steps. The timer can
be set to a value between 0:01 and 9:59 by directly using the 8 power levels (7),
without selecting a programme. The timer can be changed at any time using the
programme functions and the 8 power levels (7).
Power-Sharing (12)
The Power-Sharing function ensures optimum usage of the total power available.
If both hotplates are operated at the same time, they share the power settings via
the Power-Sharing function. As soon as the Power-Sharing function is active, it is
indicated with the red LED.
Note: If one hotplate is working at power level 7–8, the maximum power
level for the other is power level 5.