Wolf Garten POWER Base 72V Basic - General Safety Guidelines

Safety information
|

POWER Base V Basic
|
EN
Safety information
Structure
MTD Products AG
Industriestr. 23
66129 Saarbrücken
Input:
Output:
230 V ~ / 1A 50 Hz
42 V / 2x 1,5 A
AC/DC Charger
POWER Base 72V Basic
196-652-000
AxxxxMTxxxx
2016
T 3,15 A
1 Type of device (charger)
2 CE label
3 Model name
4 Rated input voltage / Kind of current,
current strength
5 For use inside buildings only
6 Rated output voltage / Kind of current
7 Read instruction manual
8 Manufacturer
9 Disposal note
10 Year of manufacture
11 Model number
12 Serial number
13 Protection class II
14 Frequency
15 Rated output current
16 Fuse
General safety information
¾ Before initial use, perform a visual
inspection of the device to check
for damage.Prior to use any damage
must be repaired by a qualied expert
or workshop.
¾ Do not use any damaged, defective
or deformed power packs.
¾ Do not charge any third party
power packs.
¾ Never try to charge non-
rechargeable power packs.
¾ Do not cover the ventilation slits of
the charger. Otherwise the charger
may overheat and no longer function
correctly.
¾ Repairs must only be performed by
aqualiedexpertorworkshop
Intended use
The device is intended for charging power packs of type Li-High Energy 72V; these are
authorised by the manufacturer. Any other use is classed as an unintended use. The
user is liable for any damages arising from unintended use.
Identicationplate
Position
The identication plate is located at the charger casing.
Note
The identication is considered as a document. It must never be altered or
obliterated.