Common Faults and Troubleshooting
Adjustment of the rear braking light
* It is important to always check the vehicle lights and make sure
they are properly functioning prior to using the vehicle. The
brake light can be inspected with the ignition turned to the on
position, and the left and right brake handle compressed.
Adjustment of the idle speed
If the vehicle stalls out during normal operation due to the engine
speed being low, the idle speed can be adjusted:
* Before adjusting the idle, make sure the engine has reached
normal operating temperature.
* Place vehicle on the main stand. While the vehicle is running
adjust the idle until the specified RPM is set.
In order to gain access to the brake switches the left and
right-side controls must be removed as well as the brake
handles. This can be performed at your local authorized
service center.
Adjust the idle speed screw here. Turning clockwise will
raise the idle; counter clockwise will lower the idle.
Rear braking
light switch
Front braking
light switch
To Next Page
Loading...
