Common Faults and Troubleshooting
Service and Maintenance for Front and Rear Tires
Prior to riding always inspect the tires. Make sure the front and rear
tire are filled to their recommended pressure. Proper tire inflation
increases riding comfort and the stability of the vehicle while
prolonging the service life of the tires.
Tire specification/air
pressure
Removal and Installation of Front Wheel
* With the engine off, place the vehicle on the center kickstand.
* Remove the nut off the front wheel bolt. Slide the bolt out while
making sure to retain all hardware including wheel spacers, and
speedometer hub.
Caution:
* Do not use the front brake with the wheel removed.
* Check the front brake Master Cylinder fluid level and top off if
needed. Verify that the wheel spins freely with no brake drag.
Warning:
* Always re-torque the front wheel nut to 40-50 ft. lbs.
Check the air pressure of the tire and visually inspect the rubber
tire and rim for excessive wear or defects. If there are any issues,
the tire should be replaced at a local authorized service center.
Failure to properly torque the front wheel nut can
lead to serious injury!
To Next Page
Loading...
