To Next PageTo Next PageWhat should I do if defrost energy in heating circuit is too low during defrosting in my Wolf BWL-1S-05?
If the defrost energy in the heating circuit is too low during defrosting, check the heating circuit flow rate and the electric heater. If necessary, briefly reduce the heating circuit volume.
What to do if there is a bus connection interrupted between IDU and ODU in my Wolf BWL-1S-05 Heat Pump?
If there is a bus connection interrupted between the IDU and ODU, check the bus cable and plug-in connections. Ensure there is communication between HCM-3, AWO-/ EWO board, and ODU. Check the AWO/EWO board and HCM-3. Verify the ODU power supply and check the ODU power supply.
Provides important safety information and symbols used in the manual.
Lists applicable standards, regulations, and directives for installation and operation.
Explains how a heat pump works, including its components and cycle.
Details recommendations for heating water quality to prevent scaling and corrosion.
Details the components and layout of the indoor module.
Lists the key features and capabilities of the indoor module.
Provides detailed dimensional drawings of the indoor module.
Provides essential guidelines for selecting the optimal installation site for the heat pump.
Shows required clearances around the indoor unit for installation.
Details how to properly route refrigerant lines, including safety and damage prevention.
Explains the procedures for connecting refrigerant lines to indoor and outdoor units.
Covers connecting the heating and DHW circuits, including filling and flushing.
Provides general safety and regulatory information for electrical connections.
Details electrical connections for the indoor module.
Overview and specifications of the AM and BM-2 control units.
Overview of the AM display module's interface and functions.
Shows the menu structure for accessing contractor settings via AM module.
Lists contractor parameters, their settings, and factory defaults.
Lists available system configurations and their brief descriptions.
Explains the conditions and requirements for active cooling mode.
Explains the Smart Grid function for optimizing energy use.
Presents charts showing heating output, power consumption, and COP.
Lists essential cleaning and check tasks for periodic maintenance.
Lists fault codes, their causes, and remedies for troubleshooting.
Presents technical data relevant to EU Regulation 813/2013.
Contains product data sheets according to EU Regulation 811/2013.
Provides a glossary of abbreviations and terms used in the manual.
General
