Wolf COB - Installation and Maintenance Information; Positioning and Modifications; Corrosion Protection

Installationinformation/Maintenance
information
6
3062548_201802
3 Installationinformation/Maintenanceinformation
3.1 Positioning/modications
- Your oil condensing boiler should only be installed and
modied by an approved heating contractor, as only they
have the essential knowledge to carry out such work.
- Flue gas components must not be modied.
- Never modify the drain or the safety valve.
Nevercloseorrestricttheventilationaperturesindoors
orwallswhenoperatingtheboilerinopenuemode;only
starttheboilerwhentheuehasbeenfullyinstalled.
Onlyoperatetheboilerinroomsealedmode,afterthe
roomsealedsystemhasbeenfullyinstalledandthewind
protectorisnotcoveredup.
Failuretocomplywiththisresultsinariskofpoisoningor
asphyxiationduetotheuegasleakingintheinstallation
room
Oilcondensingboilersmayonlybeinstalledinrooms
whichareprotectedfromfrost.
Neverisolatetheoilcondensingboilerfromthepower
supplywhenoutsidetemperaturesfallbelowfreezing!
Failuretocomplyresultsintheriskofdisruptiontothe
installation,duetotheriskofitfreezing.
Donotuseorstoreexplosiveandammablematerials,e.g.
petrol,thinners,paints,paperetc.insidetheboilerroom!
Failuretocomplywiththisrulemayleadtoariskofre,
explosion,poisoningorsuffocation!
3.2 Corrosionprotection
Donotuse(forcleaning,polishingetc.)orstoresprays,
solvents,chlorinatedcleaningagents,paints,lacquer,
adhesives,saltsetc.onorinthevicinityoftheoil
condensingboiler.Underunfavourableconditions,these
materialsmayleadtocorrosionintheboilerandtheue
system.Ductedventsroutedthrougharoofmayalsoexpel
corrosivevapours.
Note
Note