Wolf CSW-120 - Safety Notice; DHW Cylinders; Standards and Regulations

Installation instructions DHW cylinders TSW-120/CSW-120
3048420_0707
3
Safety notice / DHW cylinders / Stan-
dards and regulations
Standards and
regulations
Observe the following instructions during the installation of the
DHW cylinders:
- BS 6920
- BS 7206
- DIN 1988 - Technical regulations for DHW installations
- DIN 4708 - Centralised DHW systems
- VDE requirements
- Requirements by public water suppliers
Safety notice
• Installation must be carried out by a suitably qualified installer
and in accordance with current regulations and codes of
practice.
• Only the safety valves supplied with the cylinder should be
used.
• The cylinder must not be used without the safety valves and
expansion vessels.
• The cylinder must not be used with a boiler without thermostatic
control.
• The cylinder and ancillary controls must be adequately
maintained.
• The installation must have a sufficient and constant supply of
mains fed cold water.
• No valve should be fitted between the expansion relief valve
and the storage cylinder.
• Only Wolf approved replacement parts should be used.
• The discharge pipe must be terminated where it is visible and
will not cause danger to people in the vicinity of the discharge.
Note: The discharge could consist of scalding water and steam.
DHW cylinders, type TSW-120 / CSW-120, made from steel with
top flange and pipework connections for gas-fired boilers.
Corrosion protection through dual enamel coating on internal
cylinder walls and indirect coils, acc. to DIN 4753 pt. 3.
Additional corrosion protection through magnesium anode. Suitable
for all water conditions and any type of pipework.
DHW cylinders
Domestic hot water cylinder
TSW-120
Domestic hot water cylinder
CSW-120