10
WARMING DRAWER RACK
T
he rack will fit in the warming drawer front to
back or side to side and allows you to double
stack items. Flipping the rack upside down
p
uts it in the low rack position. The low rack
position raises items
1
/4" (6 mm) from the
bottom of the warming drawer and the high
rack position allows for double stacking items.
When holding hot, cooked foods and warming
empty serving dishes at the same time, place
the serving dishes on the rack in high position
and place the food on the bottom of the
warming drawer.
IMPORTANT NOTE:
Always preheat the
warming drawer with the rack in position.
WARMING DRAWER PAN
The warming drawer pan is removable for
cleaning. To remove, pull the warming drawer
completely open. Slide fingertips under the
right and left side edges of the pan. Firmly pull
the pan upward, making sure that all edges are
clear from the interior of the unit.
To replace the warming drawer pan, pull the
warming drawer completely open. Place pan
edges on the side rails of the drawer frame.
Make sure that the pan edges are positioned
on the sides and rear of the unit. The front of
the pan has no edge. Open and close the
drawer completely to check operation.
WARMING DRAWER OPERATION
USING THE WARMING DRAWER
A
lways start with hot food. The warming
drawer will keep hot food at serving
temperature. Do not use the warming
d
rawer to heat cold food other than for
proofing yeast dough, crisping crackers,
chips or dry cereal.
Always preheat the warming drawer. Allow
the following preheat times:
• 15 minutes for
LOW
•
20 minutes for
MEDIUM
•
30 minutes for
HIGH
NOTE: It is not necessary to preheat the
warming drawer for proofing.
Food in heat-safe glass and glass ceramic
containers may need higher temperature
settings as compared to food in metal
containers.
Repeated opening of the warming drawer
will allow hot air to escape and the food to
cool.
With large loads, it may be necessary to
use a higher temperature setting and to
cover some of the cooked food items.
Food should be kept hot in the cooking
container or transferred to a heat-safe
serving dish prior to being placed into the
war
ming drawer.
Remove serving spoons, etc., before
placing food containers in warming drawer.
Aluminum foil may be used to cover food
to increase moisture content, but may not
be used to line the interior of the war
ming
drawer.
Plastic containers or plastic wrap will melt if
placed in contact with the warming drawer
or hot utensils from the warming drawer.
Melted plastic may be difficult to remove
and is not considered a warranty repair.
WOLF WARMING DRAWER USE & CARE
To Next Page
Loading...
