Wolf WD30 - Wolf Warming Drawer Use & Care

7
BEFORE USING FOR THE FIRST TIME
Remove all literature and packaging
materials from inside the warming drawer.
Clean your warming drawer thoroughly
w
ith hot water and a mild detergent. Rinse
and dry with a soft cloth. This removes
residual oil and grease left on the surface
f
rom the manufacturing process.
Apply a stainless steel polish to protect the
finish and add luster to the exterior of your
warming drawer. Refer to Care Recommen-
dations on page 12.
MOISTURE SELECTION CONTROL
The moisture selection control is located on
the inside front of the warming drawer. Refer
to the illustration on page 6.
To keep foods moist, slide the moisture
selection lever towards the control panel. This
closes the vent and allows moisture to develop
inside of the warming drawer. With the vent
closed, hot foods will stay moist and soft.
IMPORTANT NOTE: Closing the vents may
cause condensation to occur around the inside
edge of the warming drawer.
To keep foods crisp, slide the moisture
selection lever away from the control panel.
This opens the vents and allows the moisture
to escape from inside of the war
ming drawer
.
With the vent open, food will remain crisp.
IMPOR
T
ANT NOTE:
Opening the vents may
cause condensation to occur on surfaces
above or below the warming drawer.
WOLF WARMING DRAWER USE & CARE
ACCESSORIES
Optional acces-
sories are available
through your
Wolf dealer. You
can also visit our
website at
wolfappliance.com
and click on the
accessories section
for your specific
model.
WARMING DRAWER ACCESSORIES
These optional accessories are available
through your Wolf dealer. You can also visit
o
ur website at wolfappliance.com and click
on the accessories section for the warming
drawer.
W
DFRONT/S –
C
lassic Stainless Steel
Drawer Front (with handle)
WDFRONT/P – Platinum Stainless Steel
Drawer Front (with handle)
WDFRONT/B – Carbon Stainless Steel
Drawer Front (with handle)
WDFRONT/I – Integrated Drawer Front
(accepts custom wood panel)
WDHAN/S – Classic Stainless Steel Handle
(for integrated drawer front)
WDHAN/P – Platinum Stainless Steel
Handle (for integrated drawer front)
WDHAN/B – Carbon Stainless Steel Handle
(for integrated drawer front)
WDCONTAINERS – Five-piece container
set (includes five commercial pans with
lids; one large 14-quart pan, two medium
6-quart pans and two small 3-quart pans)