AUTOMATIC SHUT-OFF ADJUST MODE
Y
our Wolf warming drawer has a factory
preset automatic shut-off time of four hours.
This automatic shut-off time interval can be
a
djusted from zero to four hours in one-hour
increments.
To Set Automatic Shut-Off:
Warming drawer must be in OFF mode.
Touch and hold the DOWN arrow.
While holding the DOWN arrow, touch
ON/OFF
, then release both pads.
The number of hours along with the
letters "
hr
" will appear in the LED display,
indicating that the unit is in automatic
shut-off adjust mode.
To adjust the time interval while in auto-
matic shut-off adjust mode, touch either the
UP or DOWN arrow pad until the desired
interval is shown in the LED display.
Touch
ON/OFF
to exit this mode and save
the new setting to memory.
NOTE: The automatic shut-off time interval is
saved, so if power is interrupted the latest
interval entered will be retained.
8
WOLF WARMING DRAWER USE & CARE
If "0 hr" is selected and saved, the unit
will run continuously.
CONTROLS
The control panel is hidden when the warming
drawer is closed. With the warming drawer
o
pen, the controls can be accessed on the right
side of the front face.
SETTING TEMPERATURE
Touch
ON/OFF
. The LED display will
indicate that the warming drawer is on.
Select a preset temperature setting or
adjust the temperature setting with the UP
and DOWN arrow pads. Touch the UP arrow
to increase the temperature and the DOWN
arrow to decrease the temperature.
Temperature Presets:
PROOF 100˚F (40˚C)
LOW 150˚F (65˚C)
MEDIUM 170˚F (75˚C)
HIGH 190˚F (85˚C)
Temperature Ranges:
PROOF 70˚–119˚F (20˚–49˚C)
LOW 120˚–159˚F (50˚–69˚C)
MEDIUM 160˚–179˚F (70˚–79˚C)
HIGH 180˚–200˚F (80˚–95˚C)
Warming drawer control panel
O
N
/
OFF contr
ol
LED Display
Pr
eset temperature
controls
Variable
temperature
controls
(UP and DOWN)
To Next Page
Loading...
