23
Wol GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 | www.wol-tools.de
► Place the tank on the lower holder (8) Pic D.
► Lock the tank with the upper holder (7).
► Insert tube shown in Pic G
- Guide the chain through the hole (Pic E)
- Attach the ring to the lever (Pic E)
► Screw the chain onto the lifting rod.
►
Check that there is no tension on the chain.
By pulling the handle (4), the cleaning liquid onto the
cleaning brush.
5.0 Ending the work
► After completing the work, the drive plate or tool
plate must be removed. When you leave the
machine, always unplug the power plug from the
socket. Never leave the drive plate or brush on
the machine after nishing work!
6.0 Maintenance
6.1 Maintenance and Cleaning
► Before any work on the machine itself, pull the
mains plug.
► For safe and proper working, always keep the ma-
chine and ventilation slots clean.
The machine must then be sent to an after-sales Ser-
vice agent. Addresses are listed in the Section “After-
sales service and customer assistance”.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
WOLFF power tools.
In all correspondence and spare parts orders, please
always include the machine number specied on the
type plate of the machine
6.2 Spare parts
Spare parts can be found on the internet at:
http://webkatalog.wol-tools.com
7.0 Trouble shooting
Fault Possible cause Remedy
8.0 Disposal information
Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an environmen-
tally correct manner.
Subject to change without notice
The machine
does not start
Power interrupted
Fuse defective
Cable defective
Plug defective
Contact Electrici-
an for repair and
/or replace parts
The machine
does not start
Guide rod incor-
rectly mounted
Install guide rod
correctly
Switch-on le-
ver (3) cannot
be operated
The safety switch
allows the lever
(3) to be operated
only when the
handle is inclined.
Tilt the handle of
the machine.
EN
To Next Page
Loading...