2
Installation
Installation
The installation must conform with local codes
or,
in
the
absence of local codes, with the National Fuel Gas Code,
ANSI 2223.1 latest edition. (EXCEPTION: Do not derate
this appliance for altitude. Maintain the manifold pressure at
3.5 inches W.C. and 10 inches W.C. for Propane).
In
Canada, installation must be in accordance with the
current CAN 1 81-149.1 and .2 Installation Codes and/or
local codes.
The
Installation
should
be
done
by
a
qualified
service
person
who
Is
familiar
with
the
building
codes
and
Installation
techniques
appropriate
for
your
area
to
accomplish
a
safe
and
effective
installation.
Your
Wonderfire
dealer
or
your
local
gas
sup-
plier
will
be
able
to
refer
a
qualified
service
person.
WARNING: DUE
TO
HIGH TEMPERATURES, THE
WONDERFIRE DIRECT VENT GAS HEATER
SHOULD BE LOCATED OUT
OF
TRAFFIC AND
AWAY FROM FURNITURE AND DRAPERIES.
THE SURFACE OF THE WONDERFIRE IS HOT
WHEN IT
IS
IN USE. YOUNG CHILDREN SHOULD
BE WATCHED CAREFULLY WHEN THEY ARE
IN
THE SAME ROOM WHEN THE WONDERFIRE IS
IN USE, AND THEY SHOULD BE TAUGHT TO
AVOID THE HOT
SURFACE.·KEEPANY
OBJECTS THAT CAN BURN WELL AWAY FROM
THE
WONDERFIRE, AND OBSERVE THE
RECOMMENDED CLEARANCES THAT FOLLOW.
Hearth Requirements
The Wonderfire must
be
installed on rigid flooring. Any
carpeting under the unit must
be
removed. When the
Wonderfire is installed directly on any combustible surface
other than wood flooring, a metal
or
wood panel extending
the full width and depth of the unit must
be
used as the
hearth. There are no other hearth requirements.
Keep the Stove a Safe Distance
from Surrounding Materials
The Wonderfire will heat nearby surfaces when operating. A
safe installation requires that adequate
clearance be
maintained between the stove and nearby combustible
materials
to
ensure that such materials
do
not overheat The
diagrams that follow illustrate the minimum clearances for the
Wonderfire Direct Vent Gas Heater in
parallel, corner. and
alcove installations.
Stove Clearances
Measure
from the rear
of the cast
iron flue
collar.
Minimum
Clearances:
Parallel
Installation.
See
Page
10
for
specific
installation
procedures.
~----------------------------------~.
Minimum
Clearances;
Corner
Installation.
To Next Page
Loading...