What to do if drive belts come off pulleys when disengaging blade on Wood-Mizer Saw?
If the drive belts on your Wood-Mizer Saw come off the pulleys when disengaging the blade, it could be due to a brake strap that is too loose, a misaligned brake drum, or a brake strap that's unevenly tightened. To resolve this, adjust the brake strap and realign the brake drum on the drive shaft.
How to fix Wood-mizer LT20 AH Saw blade that does not track right?
If the blade on your Wood-Mizer Saw does not track correctly, it may be due to an incorrect cant adjustment or flat/worn belts. Readjust the cant on the drive wheel or replace the B-57 belts.
Why do Wood-Mizer Saw blades dull quickly?
If the blades of your Wood-Mizer Saw are dulling quickly, it may be caused by dirty logs, overheating during grinding, or poor sharpening techniques. Clean or debark the logs, especially on the entry side of the cut. When grinding, remove just enough metal to restore sharpness and use water or coolant. Ensure proper sharpening techniques, paying attention to the tip.
Why do Wood-mizer LT20 AH blades break prematurely?
If the blades on your Wood-Mizer Saw are breaking prematurely, it could be due to worn rubber belts on the blade wheels, poor sharpening techniques, or excessive tension. Replace the blade wheel belts (B-57). Ensure correct sharpening techniques. Reduce the blade tension to the recommended specifications.
What to do if Wood-mizer LT20 AH blade does not stop immediately after disengaging?
If the blade of your Wood-Mizer Saw does not stop immediately after disengaging, the brake strap might be too loose. Adjust the brake strap to resolve this.
What to do if blade guides do not spin while cutting with Wood-Mizer Saw?
If the blade guides on your Wood-Mizer Saw do not spin while cutting, it could be because of frozen or stiff bearings. Replace frozen bearings or grease stiff bearings to resolve this.
General| Model | LT20 AH Series |
|---|---|
| Engine Power | 11 kW (Electric) |
| Max Log Diameter | 80 cm |
| Bed Length | 6.4 m |
| Weight | 1200 kg |
Guidelines and warnings for operating the sawmill safely.
General safety guidelines and important precautions for users.
Instructions and conditions for setting up the sawmill.
Detailed steps for setting up a stationary version of the sawmill.
Step-by-step guide for setting up the portable sawmill.
Procedure for safely removing and installing a new saw blade.
How to properly tension the saw blade for optimal cutting.
Steps to ensure the blade tracks correctly on the wheels.
Procedures for safely starting the sawmill's motor.
Step-by-step guide for loading and securing logs.
How to use the up/down controls for cutting head height adjustment.
Adjusting the blade guide arm for optimal cutting performance.
Instructions for using the power feed system for carriage movement.
Comprehensive guide to cutting logs with the sawmill.
How to use and adjust the blade height scale for precise cuts.
Steps to prepare the sawmill for safe transportation.
Solutions for common issues related to sawing performance.
Troubleshooting steps for electrical issues in the sawmill.
Diagnosing and resolving problems with the power feed system.
Solutions for issues related to the hydraulic system.
Initial steps and guidelines for sawmill alignment.
Instructions for setting up the sawmill frame for alignment.
To Next Page