Wood-mizer MP260 - Page 7

INTRODUCTION
Machine description
INTRODUCTION doc081920 1-4
1
ANCHORING
It is recommended that the MP260 planer/moulder be anchored to the floor using 12 mm screws.
LIST OF THE TOOLS REQUIRED TO WORK WITH THE PLANER/ MOULDER:
 Hex key 4 mm (supplied)
 Hex key 5 mm
 Hex key 6 mm
 Open ended wrench 10 mm (supplied)
 Wrench 10 mm
 Ring wrench 13 mm
 Open ended wrench 30 mm (supplied)
 Adjustable wrench 8" or 10"
 Sliding caliper
 Measuring tape or ruler
 Paraffin oil for the table
 Whetstone
FOLLOWING SPACER RINGS ARE SUPPLIED:
 3 x 40 mm height (per cutter)
 2 x 20 mm height (per cutter)
 2 x 10 mm height (per cutter)
 1 x 5 mm height (per cutter)
 2 x 2 mm height (per cutter)
 1 x 1 mm height (per cutter)
 1 x 0.5 mm height (per cutter)
 2 x 0.2 mm height (per cutter)
 1 x 0.1 mm height (per cutter)