Wood-mizer MP260 - Replacing bottom horizontal cutter belt

Maintenance
Replacing bottom horizontal cutter belt
Maintenance doc081920 5-16
5
Replacing bottom horizontal cutter belt
1. Loosen and remove mounting bolts (A) with washers. Remove the belt cover (B).
2. Loosen the locking nut (C).
3. Pull the motor with pulley up and remove the belt.
4. Mount the new belt and slowly lower the motor with pulley to tighten the belt.
5. Tighten the belt properly. Do not over-tighten the belt. Properly tightened belt should be
deflected by 1,5cm with a force of 10 kg.
6. Check motor and bottom cutter pulleys alignment. Both pulleys should be in line to avoid
premature drive belt wear. Loosen pulley screw on the motor shaft to move pulleys. After
pulleys alignment, recheck the belt tension.
See Figure 5-17.
FIG. 5-17
MP260_008
MP260EH13S-V_MANUAL_OPER
B
C
A