Assembly 32
MAN1256 (3/23/2018)
Chain Shielding
The chain shielding assemblies are ready for installation when you receive
them.
1.
Install front and rear chain shielding as shown using carriage bolts (8)
and flanged lock nuts (9).
2.
Attach front reflector bracket (3) over left front shield.
3.
Attach front reflector bracket (3) over left front shield
.
Figure 36
. DS8.30E & DS10.40E Chain Shielding Installation
DEALER CHECK LISTS
PRE-DELIVERY CHECK LIST
(DEALER’S RESPONSIBILITY)
Inspect cutter thoroughly after assembly to make sure it is set up properly
before delivering it to the customer. The following check list is a reminder of
points to inspect. Check off each item as it is found satisfactory, corrections are
made, or services are performed.
NOTICE
■
Gearbox was not filled at the factory. It must be serviced before
operating cutter. (See LUBRICATION, page 15). Failure to service will
result in damage to gearbox.
___ Check that gearbox is properly serviced and seals are not leaking.
___ Check and grease all lubrication points as identified in Owner Service,
LUBRICATION, page 15.
___ Check that blades have been properly installed.
___ Check all bolts to be sure they are properly torqued.
___ Check that all cotter pins are properly installed and secured.
___ Check that PTO shaft is properly installed.
DELIVERY CHECK LIST
(DEALER’S RESPONSIBILITY
___ Show customer how to make adjustments. Describe the options avail-
able for this cutter and explain their purpose.
___ Explain importance of lubrication to customer and point out lubrication
points on cutter.
___ Point out all guards and shielding. Explain their importance and the
safety hazards that exist when not kept in place and in good condition.
___ For mounted units, add wheel weights, ballast in front tires, and/or front
tractor weight to enhance front end stability. A minimum 20% of tractor
and equipment gross weight must be on front tractor wheels. When
adding weight to attain 20% of tractor and equipment weight on front
tractor wheels, you must not exceed the ROPS weight certification.
Weigh the tractor and equipment. Do not estimate!
___ Present Operator's Manual and request that customer and all opera-
tors read it before operating equipment. Point out the manual safety
rules, explain their meanings and emphasize the increased safety haz-
ards that exist when safety rules are not followed.
Explain to customer that when equipment is transported on a road or highway,
safety devices should be used to give adequate warning to operators of other
vehicles.
1. Front chain shield bracket
2. Rear chain shield bracket
3. Front reflector bracket
4. 5/16 - 5 Link chain
5. 5/16 - 4 link chain
6. .243 Dia bent pin
7. .243 Dia bent pin
8. 3/8 NC x 1 Carriage bolt
9. 3/8 NC Flange lock nut
To Next Page
Loading...
